Popular posts from this blog
Week 6
In week 6 we have began drafting our student and teacher lab manuals. These manuals will describe everything required for the experiment including, equations, data charts, procedures, and materials. We added the notches to our "tree" for the weights to hang in place. Our 3D printed balance beam is now in the works and should take about 8 hours to finish. Until then, we will wait.
Week 7
Our 3D printed balance beam has finally been printed! However, after multiple tests and playing around with, we have decided the beam does not serve the lab well enough. It is too small and difficult to work with. By the end of the week we will try and figure out an alternative prop for our balancing experiment.
Comments
Post a Comment