Week 7

Our 3D printed balance beam has finally been printed! However, after multiple tests and playing around with, we have decided the beam does not serve the lab well enough. It is too small and difficult to work with. By the end of the week we will try and figure out an alternative prop for our balancing experiment.

















Comments

Post a Comment

Popular posts from this blog

Week 3

Image
Week 3 was very productive. The project proposal has been completed and uploaded to the blog. From three experiments, we have narrowed it down to one. Our final decision is the Center of Mass lab. This lab will be split into three, 50 minute experiments for a middle school class. We have started putting together designs and sketches for the labs. Next week we will begin prototypes and may get an attempt at the 3D printer.
Read more

Project Overview

For this design project, we plan to experiment with the primary concept of center of mass. This idea will be transformed into three, fifty-minute experiments. One experiment will be designing a structure with multiple tiers. Various sized weights will be distributed throughout the structure, and the main goal would be to calculate the center of mass. Another experiment would utilize the 3D printer. Creating a small teeter-totter with the printer and rolling different objects (toy cars, marbles, etc.) will display the importance of the center of mass. For the third experiment, we will demonstrate how mass affects balance. We plan on teaching middle school classes the fundamental physics and advanced problem-solving skills with engaging exercises. Some challenges that may be faced is our ability to get our message and the directions across to the audience. Some significant tasks are going to be to construct the props for our experiments and evaluating the necessary calculations. The fina
Read more

Gantt Chart

Image
Here is our Gantt chart for our engineering project. We developed this through researching example engineering Gantt charts and from previous experience.
Read more